Mini Titan E325 Power System Combo
- Manufacturer: Thunder Tiger
- Condition: New
| Voltage range( V ) | 2~3S Li-Po Battery |
|---|---|
| RPM per volt(RPM/Volt) | 3500 RPM/V |
| Dimensions ψx L(mm/in) | 28.5 x 28.1 mm (1.12 x 1.11 in) |
| Shaft Diameter ψ(mm/in) | 3.175mm (0.125 in) |
| Max.efficiency current(A) | 4~20A |
| Current capacity(A/s ) | |
| Internal resistance(mΩ) | 36 mΩ |
| Recommend Propeller | |
| Weight(g/oz) | 55 / 1.94 |
| KV Rating (PRM/Volt) | |
| Max. Surge Current(A/s) | 30A / 60s |
Content
1) Ripper outrunner brushless motor x 1
2) Heat shrink x 3
3) Golden Connector (male) x 3
4) Golden Connector (female) x 3
5) Screw Set x 1
6) L Type hex wrench ( 2.5 mm) x 1
7) Instruction Manual x 1
Introduction
The Ripper OBL outrunner motors are designed for R/C electric helicopters. Thunder Tiger provides a brand new range of brushless motors to satisfy all your flying needs. Extremely high torque and masses of power for a motor of its size. With the best cooling design, you can get the best efficiency out of the motor.
Features
1) The perfect current capacity for long time flying
2) Provides extremely high torque for flying
3) The most efficiently RPM value
4) The maximum efficiency current
5) The best mechanical design for cooling motor
6) Light weight with the best performance
7) Dual Ball Bearing shaft support
8) Special designed for small size electric helicopter of 3S Li-Po Battery setup.
| Voltage Range(V) | 7.4~14.8 V (2~4S Li-Po) |
|---|---|
| Internal resistance(mΩ) | |
| Continuous Load(A) | 40A |
| BEC Voltage(V) | 5V |
| BEC Current(A) | 2A |
| Motor Limit | |
| Reverse | |
| Reverse Limit (sec) | |
| Over Load Protection | Temp. Protection |
| Low Battery Cutoff | |
| Setup Procedure | Digital |
| Governor Mode | Yes |
| Rec.Model | |
| Dimension (mm) | 52 x 24 x 7.9 |
| Weight (g/oz.) | 27 /0.95 |
| Rec.vehicle |
Content
1) Brushless Speed Controller x 1
2) Golden Plug set (φ4mm/ femal & male) x 2
3) Instruction Manaul
Introduction
Thunder Tiger introduces their brand NEW speed controls for brushless motors. The BLC-40 is designed for the mini-sized electric aero-vehicle.
Capable of supplying up to 40 Amps of continuous motor current. Small and lightweight, with a large heat sink surface area. Perfect for the Thunder Tiger OBL series brushless motors. And for safety consideration. there are built-in safety features to prevent accidental motor startup when powering on.
There are 2 version of the BLC-40 speed controller can be choosed to fit the difference model. The only difference is on the factory default setting program. BLC-40A is set for the aircraft model and BLC-40H is set for the helicopter.
Features
1) Low battery protection
2) Over temperature protection
3) Motor timing adjustment
4) Brake control
5) Throttle response adjusment
6) Plane and helicopter mode
7) Governor mode for helicopter
8) Soft start
9) Anti-interference ring
