ESky Professional Head Lock Gyro EK2-0704B
Click To Enlarge
- Manufacturer: TWF - ESKY
- Condition: New
Specification:
- Input signal:1.5±0.5ms
- Input power: 5~6VDC
- Weight: 12.5g
- Size: 27 x 28.5 x 18mm
Feature Illumination:
- can be used on Engine and Electric Helicopters
- dual sensibility adjusting - nose locked model and standard model;
- suitable for 4ch and 6ch transmitter;
- with a built-in temperature equalizing electrocircuit;
- to both 6CH and 4CH transmitters, the gain value can be adjusted through crust
Installation:
- the EK2-0704B headlock gyro must be installed horizontally (LED faces upward)
- For ESky Belt-CP and Honey Bee King 2, please make sure it is at "NOR" position
- the headlock gyro (3pins) cable should connect to the channel 4 on the receiver
- the tail servo should connect to the headlock gyro (black wire near the edge)
- Servo Limit on the gyro about 10%
- Delay Switch on the gyro about 70-80%
- you can choose not to connect the single orange cable to channel 5 on the receiver. if the gain of the headlock gyro > 50, it is in the headlocking mode. If gain < 50, it will be in the normal mode
- please tie up all the cables before fly, this is to prevent loose cables to touch the main gear or motor
- the photo shows only an example on how to mount the headlock gyro, you may choose to mount it on the main body of the helicopter.
